76 - Eureka Broadway Gas & Deli Mini-Mart

4050 Broadway, Eureka

Routine Inspection

ROACHY SAYS:

“Wow! Roachy can see himself in your butterknives! Way to go, 76 - Eureka Broadway Gas & Deli Mini-Mart!!”

Routine Inspection
22. Hot and Cold Water Available

Conditions Observed: Hot water at warewashing sink measure 113.8 F. Water shall have a minimum temperature of 120F. Person in charge cranked up heater. At end of inspection, water measured 120F.

ROACHY SAYS:

“An adequate, protected, pressurized, approved potable supply of hot and cold water shall be provided at all times. Hot water shall be supplied at a minimum temperature of 120F when measured from the faucet. The temperature of water provided to handwashing facilities shall be at least 100F. Handwashing facilities equipped with non-adjustable faucets shall have their temperature set between 100F and 108F. Hot water shall be provided at the food preparation sink and janitorial sink. (113953(c), 114099.2(b), 114163(a)(3), 114189, 114192, 114192.1, 114195)”

45. Floor, walls, and ceilings: built, maintained, clean.

Conditions Observed: Observed debris accumulation in back storage room floor. Please maintain clean.

ROACHY SAYS:

“Food facilities shall be fully enclosed in a building consisting of permanent floors, walls, and an overhead structure that meets minimum standards. The walls and ceiling shall be smooth, durable, nonabsorbent, and easily cleanable. Flooring and base coving shall be smooth, durable, and made of approved nonabsorbent material that is easily cleanable. Floor surfaces shall be coved at the juncture of the floor and wall with a 3/8 inch minimum radius and shall extend up the wall at least 4 inches. (114143(d), 114266, 114268, 114268.1, 114271, 114272)”

Routine Inspection

ROACHY SAYS:

“Wow! Roachy can see himself in your butterknives! Way to go, 76 - Eureka Broadway Gas & Deli Mini-Mart!!”

Routine Inspection
22. Hot and Cold Water Available

Conditions Observed: # comp sink hot water at 110.5 Please provide water of at least 117F.

ROACHY SAYS:

“An adequate, protected, pressurized, approved potable supply of hot and cold water shall be provided at all times. Hot water shall be supplied at a minimum temperature of 120F when measured from the faucet. The temperature of water provided to handwashing facilities shall be at least 100F. Handwashing facilities equipped with non-adjustable faucets shall have their temperature set between 100F and 108F. Hot water shall be provided at the food preparation sink and janitorial sink. (113953(c), 114099.2(b), 114163(a)(3), 114189, 114192, 114192.1, 114195)”

32. Consumer self-service.

Conditions Observed: Forks and spoons at coffee dispensing area found with handles down. Please correct. Mouth side shall be facing down. COS.

ROACHY SAYS:

“Unless otherwise specified, raw, non-prepackaged food of animal origin shall not be offered for consumer self-service. Consumer self-service operations for ready-to-eat foods such as buffets and salad bars shall be provided with a suitable food dispensing utensil for each container displayed or effective dispensing methods that protect the food from contamination. Except for drinking cups, food employees and consumers shall not be allowed to use soiled tableware, including single-use articles, to obtain additional food from the display and servicing equipment. Consumer self-service bulk beverages shall be dispensed in an approved manner. (114063, 114065)”

36. Equipment / Utensils approved; installed, clean, good repair, capacity.

Conditions Observed: Back area lacks a handwashing sink. Observed an accumulation of old debris at coffee dispenser catch basin. Please maintain clean

ROACHY SAYS:

“Utensils and equipment shall be kept fully operative and in good repair. All new and replacement equipment shall be properly installed and be certified or classified for sanitation by an ANSI accredited certification program. Electrical appliances must meet UL standards. Single-use articles shall not allow migration of deleterious substances or impart colors, odors, or tastes to food. Multi-use food contact surfaces must be smooth, free of breaks, chips, and similar imperfections; free of sharp internal angles, corners, and crevices; finished to have smooth welds and joints; be accessible for cleaning and inspection. Unless specified, wood and wood wicker may not be used as a food-contact surface. Unless specified, copper and copper alloys such as brass may not be used in contact with a food that has a pH below six or for a fitting between a backflow preventer and a carbonator. Beverage tubing and cold-plate beverage cooling devices cannot be installed in contact with stored ice intended to be used as food. Equipment that is not movable must be installed to allow for cleaning in place. Cutting or piercing parts of can openers must be readily removable. Facilities that wash, rinse, soak, thaw, or similarly prepare foods shall be provided with a approved food preparation sink. Reservoirs that supply water to produce foggers must be cleaned and maintained. Surfaces such as cutting blocks and boards that are subject to scratching and scoring shall be resurfaced or replaced if they can no longer be effectively cleaned and sanitized. (114130, 114130.1, 114130.2, 114130.3, 114130.4, 114130.5, 114130.6, 114132, 114133, 114137, 114139, 114153, 114163, 114165, 114167, 114169, 114175, 114177, 114180, 114182)”

40. Wiping cloths: properly used and stored.

Conditions Observed: At time of inspection, did not observe wiping cloths setup for sanitizing surfaces. Discussed use of sanitizing cloths. COS employee set up a solution with 300ppm DQ

ROACHY SAYS:

“Wiping cloths used to clean food spills shall be used only once or stored in a sanitizing solution of an approved concentration as specified in section 114099.6. Dry or wet cloths that are used with raw foods of animal origin shall be kept separate from cloths used for other purposes, cloths that come into contact with raw foods of animal origin shall be kept in a separate sanitizing solution. Wiping cloths shall be free of food debris and visible soil. Working containers of sanitizing solutions for storage of in-use wiping cloths shall be used in a manner to prevent contamination of food, equipment, utensils, linens, or single-use articles. Wet wiping cloths shall be laundered daily. Dry wiping cloths shall be laundered as necessary to prevent contamination of food and clean serving utensils. (114135, 114185.1, 114185.3(d-e))”

41. Plumbing: proper backflow devices.

Conditions Observed: Ice machine lacking one inch air gap at drain line. Please correct.

ROACHY SAYS:

“Steam tables, ice machines, ice bins, food preparation sinks, display cases, walk-in refrigeration units, and other similar equipment that discharge liquid waste shall drain into a floor sink with an air gap or other approved type of receptor. All plumbing and plumbing fixtures shall be installed in compliance with applicable local plumbing ordinances, maintained so as to prevent any contamination, kept clean, fully operative, and in good repair. The potable water supply shall be protected with a backflow or back siphonage protection device. Any hose used for potable water shall be of approved materials, labeled, properly stored, and used for no other purpose. Liquid drain lines shall not pass through an ice machine or an ice storage bin. (114171, 114190, 114192, 114193, 114193.1, 114199, 114201, 114269)”

43. Toilet facilities: properly constructed, supplied, cleaned.

Conditions Observed: Observed toilet bowl unclean. Please maintain clean.

ROACHY SAYS:

“Toilet facilities shall be maintained and kept clean. Toilet rooms shall be separated by a well-fitting, self-closing door. Toilet tissue shall be provided in a permanently installed dispenser at each toilet. (114250, 114250.1, 114276)”

45. Floor, walls, and ceilings: built, maintained, clean.

Conditions Observed: Observed debris accumulation beneath walk in metro shelves. Please maintain clean.

ROACHY SAYS:

“Food facilities shall be fully enclosed in a building consisting of permanent floors, walls, and an overhead structure that meets minimum standards. The walls and ceiling shall be smooth, durable, nonabsorbent, and easily cleanable. Flooring and base coving shall be smooth, durable, and made of approved nonabsorbent material that is easily cleanable. Floor surfaces shall be coved at the juncture of the floor and wall with a 3/8 inch minimum radius and shall extend up the wall at least 4 inches. (114143(d), 114266, 114268, 114268.1, 114271, 114272)”

© 2021 Lost Coast Communications Contact: news@lostcoastoutpost.com.