Hot Brew
904 S Fortuna Blvd, Fortuna
Friday, Nov. 12, 2021 (2 violations)
Routine Inspection
36. Equipment / Utensils approved; installed, clean, good repair, capacity.
ROACHY SAYS:
“Utensils and equipment shall be kept fully operative and in good repair. All new and replacement equipment shall be properly installed and be certified or classified for sanitation by an ANSI accredited certification program. Electrical appliances must meet UL standards. Single-use articles shall not allow migration of deleterious substances or impart colors, odors, or tastes to food. Multi-use food contact surfaces must be smooth, free of breaks, chips, and similar imperfections; free of sharp internal angles, corners, and crevices; finished to have smooth welds and joints; be accessible for cleaning and inspection. Unless specified, wood and wood wicker may not be used as a food-contact surface. Unless specified, copper and copper alloys such as brass may not be used in contact with a food that has a pH below six or for a fitting between a backflow preventer and a carbonator. Beverage tubing and cold-plate beverage cooling devices cannot be installed in contact with stored ice intended to be used as food. Equipment that is not movable must be installed to allow for cleaning in place. Cutting or piercing parts of can openers must be readily removable. Facilities that wash, rinse, soak, thaw, or similarly prepare foods shall be provided with a approved food preparation sink. Reservoirs that supply water to produce foggers must be cleaned and maintained. Surfaces such as cutting blocks and boards that are subject to scratching and scoring shall be resurfaced or replaced if they can no longer be effectively cleaned and sanitized. (114130, 114130.1, 114130.2, 114130.3, 114130.4, 114130.5, 114130.6, 114132, 114133, 114137, 114139, 114153, 114163, 114165, 114167, 114169, 114175, 114177, 114180, 114182)”
38. Adequate ventilation and lighting, designated areas, use.
ROACHY SAYS:
“Approved exhaust hoods shall be provided to remove toxic gases, heat, grease, vapors and smoke. Canopy-type hoods shall extend six inches beyond all cooking equipment. Toilet rooms shall be consistent with local building codes and vented to the outside air by a screened openable window, air shaft, or light-switch activated exhaust fan. Adequate lighting shall be provided in all areas to facilitate cleaning and inspection. Light fixtures in areas where open food is stored, served, prepared, and where utensils are washed shall be of shatterproof construction or protected with light shields. (114149, 114149.1, 114149.2, 114149.3, 114252, 114252.1)”
Thursday, March 18, 2021 (0 violations)
Routine Inspection
ROACHY SAYS:
“Ooo! Welcome to Sanitarytown! Population: Hot Brew! I see lots of happy hungry mouths in this establishment's near future!!”
Tuesday, Oct. 27, 2020 (0 violations)
Routine Inspection
ROACHY SAYS:
“Humboldt foodies rejoice! Our reports show that Hot Brew knows how to get you fed in a sanitary manner. Now that's nummy!!”
Wednesday, June 10, 2020 (1 violation)
Routine Inspection
22. Hot and Cold Water Available
Conditions Observed: Observed the hot water at the 3 compartment sink was approximately 110F at the time of inspection. Adjust, repair, or replace water heater to provide a minimum of 120F water. Operator agrees to monitor the water temperature.
ROACHY SAYS:
“An adequate, protected, pressurized, approved potable supply of hot and cold water shall be provided at all times. Hot water shall be supplied at a minimum temperature of 120F when measured from the faucet. The temperature of water provided to handwashing facilities shall be at least 100F. Handwashing facilities equipped with non-adjustable faucets shall have their temperature set between 100F and 108F. Hot water shall be provided at the food preparation sink and janitorial sink. (113953(c), 114099.2(b), 114163(a)(3), 114189, 114192, 114192.1, 114195)”
Wednesday, May 29, 2019 (2 violations)
Routine Inspection
08. Proper hot and cold holding temperatures.
Conditions Observed: Observed the Kelvinator refrigerator is holding at about 45F. Adjust, repair, or replace to hold at or below 41F. Operator states the refrigerator is scheduled to be replaced soon.
ROACHY SAYS:
“Except during preparation, cooking, cooling, transportation to or from a retail food facility for a period of less than thirty minutes, when time is used as the public health control, or as otherwise specified, potentially hazardous foods shall be maintained at or below 41F or at or above 135F. The following foods may be held at or below 45F: raw shell eggs, unshucked live molluscan shellfish, pasteurized milk and pasteurized milk products in original sealed containers, potentially hazardous foods held during transportation. Potentially hazardous foods held for dispensing in serving lines and salad bars may be held at 45F, not to exceed 12 hours in a 24 hour period, if unused portions are discarded. Food preparation shall not exceed two cumulative hours without a return to the required holding temperatures. (113996, 113998, 114037, 114343(a))”
34. Non-food-contact surfaces clean.
Conditions Observed: Observed some food and debris below cookline equipment and dry storage shelves. Clean and sanitize regularly to prevent build up, and to prevent providing a food source for vermin.
ROACHY SAYS:
“Nonfood-contact surfaces of equipment shall be kept free of an accumulation of dust, dirt, food residue, and other debris. (114115(b))”
Wednesday, Feb. 20, 2019 (1 violation)
Routine Inspection
45. Floor, walls, and ceilings: built, maintained, clean.
Conditions Observed: Observed build up behind refrigerators, freezers, and cookline equipment. Clean and sanitizer these areas regularly to prevent build up of food and debris.
ROACHY SAYS:
“Food facilities shall be fully enclosed in a building consisting of permanent floors, walls, and an overhead structure that meets minimum standards. The walls and ceiling shall be smooth, durable, nonabsorbent, and easily cleanable. Flooring and base coving shall be smooth, durable, and made of approved nonabsorbent material that is easily cleanable. Floor surfaces shall be coved at the juncture of the floor and wall with a 3/8 inch minimum radius and shall extend up the wall at least 4 inches. (114143(d), 114266, 114268, 114268.1, 114271, 114272)”