Jacoby Creek School
1617 Old Arcata RD, Bayside
Monday, Sept. 27, 2021 (1 violation)
Routine Inspection
22. Hot and Cold Water Available
Conditions Observed: Measured water at the kitchen sink today to be 104 F. FSM is aware of the issue and plans on installing a new water heater next week. Per FSM, utensils are returned to Sunnybrae Middle School for warewashing. Adjust/service/repair to deliver hot water at 120 F or greater. Provide proof of this correction to your inspector before 10/15/21.
ROACHY SAYS:
“An adequate, protected, pressurized, approved potable supply of hot and cold water shall be provided at all times. Hot water shall be supplied at a minimum temperature of 120F when measured from the faucet. The temperature of water provided to handwashing facilities shall be at least 100F. Handwashing facilities equipped with non-adjustable faucets shall have their temperature set between 100F and 108F. Hot water shall be provided at the food preparation sink and janitorial sink. (113953(c), 114099.2(b), 114163(a)(3), 114189, 114192, 114192.1, 114195)”
Thursday, April 8, 2021 (0 violations)
Routine Inspection
ROACHY SAYS:
“Zero violations! Now that's how you keep 'em coming back for more! I'll be sending all my human friends to Jacoby Creek School! Yum yum!!”
Thursday, Oct. 8, 2020 (0 violations)
Routine Inspection
ROACHY SAYS:
“Huzzah! This establishment has successfully impressed the government! Kudos, Jacoby Creek School!!”
Thursday, June 11, 2020 (0 violations)
Routine Inspection
ROACHY SAYS:
“Wow! Roachy can see himself in your butterknives! Way to go, Jacoby Creek School!!”
Monday, Nov. 4, 2019 (1 violation)
Routine Inspection
40. Wiping cloths: properly used and stored.
Conditions Observed: Measured QT in sani-bucket to be 100 PPM. Operator emptied and refilled; measured QT to be 200 PPM. COS. Keep wiping cloths in an approved sanitizing solution.
ROACHY SAYS:
“Wiping cloths used to clean food spills shall be used only once or stored in a sanitizing solution of an approved concentration as specified in section 114099.6. Dry or wet cloths that are used with raw foods of animal origin shall be kept separate from cloths used for other purposes, cloths that come into contact with raw foods of animal origin shall be kept in a separate sanitizing solution. Wiping cloths shall be free of food debris and visible soil. Working containers of sanitizing solutions for storage of in-use wiping cloths shall be used in a manner to prevent contamination of food, equipment, utensils, linens, or single-use articles. Wet wiping cloths shall be laundered daily. Dry wiping cloths shall be laundered as necessary to prevent contamination of food and clean serving utensils. (114135, 114185.1, 114185.3(d-e))”
Thursday, April 18, 2019 (2 violations)
Routine Inspection
22. Hot and Cold Water Available
Conditions Observed: Measured hot water to be 116.5 F. Adjust/service/repair to deliver hot water at 120 F or greater.
ROACHY SAYS:
“An adequate, protected, pressurized, approved potable supply of hot and cold water shall be provided at all times. Hot water shall be supplied at a minimum temperature of 120F when measured from the faucet. The temperature of water provided to handwashing facilities shall be at least 100F. Handwashing facilities equipped with non-adjustable faucets shall have their temperature set between 100F and 108F. Hot water shall be provided at the food preparation sink and janitorial sink. (113953(c), 114099.2(b), 114163(a)(3), 114189, 114192, 114192.1, 114195)”
36. Equipment / Utensils approved; installed, clean, good repair, capacity.
Conditions Observed: Observed build-up on triangular prong of table mounted can opener. Per FSM, can opener is not used. Remove debris to keep operational or consider removing can opener from the facility.
ROACHY SAYS:
“Utensils and equipment shall be kept fully operative and in good repair. All new and replacement equipment shall be properly installed and be certified or classified for sanitation by an ANSI accredited certification program. Electrical appliances must meet UL standards. Single-use articles shall not allow migration of deleterious substances or impart colors, odors, or tastes to food. Multi-use food contact surfaces must be smooth, free of breaks, chips, and similar imperfections; free of sharp internal angles, corners, and crevices; finished to have smooth welds and joints; be accessible for cleaning and inspection. Unless specified, wood and wood wicker may not be used as a food-contact surface. Unless specified, copper and copper alloys such as brass may not be used in contact with a food that has a pH below six or for a fitting between a backflow preventer and a carbonator. Beverage tubing and cold-plate beverage cooling devices cannot be installed in contact with stored ice intended to be used as food. Equipment that is not movable must be installed to allow for cleaning in place. Cutting or piercing parts of can openers must be readily removable. Facilities that wash, rinse, soak, thaw, or similarly prepare foods shall be provided with a approved food preparation sink. Reservoirs that supply water to produce foggers must be cleaned and maintained. Surfaces such as cutting blocks and boards that are subject to scratching and scoring shall be resurfaced or replaced if they can no longer be effectively cleaned and sanitized. (114130, 114130.1, 114130.2, 114130.3, 114130.4, 114130.5, 114130.6, 114132, 114133, 114137, 114139, 114153, 114163, 114165, 114167, 114169, 114175, 114177, 114180, 114182)”