Marcelli's Ravioli + Sausage Factory Restaurant

1323 5th St, Eureka

Routine Inspection

ROACHY SAYS:

“Humboldt foodies rejoice! Our reports show that Marcelli's Ravioli + Sausage Factory Restaurant knows how to get you fed in a sanitary manner. Now that's nummy!!”

Routine Inspection
01. Demonstration of knowledge; food safety certification.

Conditions Observed: Facility no longer has a Food Safety Manager (FSM). Obtain FSM certificate within 60 days and submit a copy to this office for verification prior to 8/24/19 to avoid a reinspection.

ROACHY SAYS:

“The Person In Charge (PIC) and all employees shall have adequate knowledge and shall be properly trained in food safety as it relates to their assigned duties. The PIC shall have adequate knowledge of major food allergens, foods identified as major food allergens, and the symptoms that a major food allergen could cause. The PIC means a designated person who has knowledge of safe food handling practices and the major food allergens as they relate to the specific food preparation activities that occur at the food facility. (113947)”

27. Approved thawing methods used; frozen food.

Conditions Observed: Observed buckets of food thawing on floor in back storage room. Food shall be maintained under temperature control during thawing by one of the methods listed above. Operator moved buckets of food to walk-in refrigerator to finished thawing. Thank you for correcting this minor violation.

ROACHY SAYS:

“Frozen foods shall be stored or displayed in their frozen state unless being thawed in the following manner: under refrigeration that maintains the food temperature at 41F or below, completely submerged under potable running water for a period not to exceed two hours at a water temperature of 70F or below and with sufficient water velocity to agitate and flush off loose particles into the sink drain, in a microwave oven if immediately followed by immediate preparation, or as part of a cooking process. (114018, 114020)”

28. Food separated and protected.

Conditions Observed: Observed open bulk bags of food stored in prep area. Once a bulk bag of food is opened, transfer it to a rigid container with a tight fitting lid to prevent contamination and potential vermin attraction.

ROACHY SAYS:

“Food shall be protected from contamination during transportation, storage, preparation, holding, and display. Adequate and suitable counter space shall be provided for all food preparation. Food preparation shall be conducted wthin an approved food compartment or fully enclosed food facility. Open-air barbecues shall be separated from public access. (113984(a-f), 113986, 114060, 114067(a,d,e,j), 114069(a, c, d), 114077, 114089.1(c), 114143(c,e))”

31. Food storage; food storage containers identified.

Conditions Observed: Observed buckets of food on the floor in walk-in refrigerator and freezer. Store foods at least 6 inches above the floor.

ROACHY SAYS:

“Adequate and suitable space shall be provided for the storage of food. Food shall be protected from contamination by storing the food in a clean, dry location, where it is not exposed to splash, dust, vermin, or other forms of contamination or adulteration, and at least six inches above the floor. Food shall not be stored in any of the following ways: in locker rooms, toilet rooms, dressing rooms, refuse rooms, mechanical rooms, under sewer lines that are not shielded to intercept potential drips, under leaking water lines, including leaking automatic fire sprinklers heads, or under lines on which water has condensated, under open stairwells or under sources of contamination. Working containers holding food or food ingredients that are removed from their original packages for use in the food facility shall be identified with the common name of the food. Non-prepackaged food may not be stored in direct contact with undrained ice. Products that are held by the permit holder for credit, redemption, or return to the distributor, such as damaged, spoiled, or recalled products shall be segregated and held in designated areas that are separated from food, equipment, utensils, linens, and single-use articles. (114047, 141049, 114051, 114053, 114055, 114067(h), 114069(b))”

34. Non-food-contact surfaces clean.

Conditions Observed: Observed non-food contact surfaces of equipment are visibly soiled (interior/exterior of refrigerators/freezers, cabinets, exterior of bulk food containers, interior of microwaves). Clean non-food contact surfaces of equipment regularly to prevent buildup.

ROACHY SAYS:

“Nonfood-contact surfaces of equipment shall be kept free of an accumulation of dust, dirt, food residue, and other debris. (114115(b))”

36. Equipment / Utensils approved; installed, clean, good repair, capacity.

Conditions Observed: Observed standing liquid and mold-like substance in bottom interior of keg refrigerator. Find source of leak and repair. Clean interior surface regularly to prevent mold-growth. Observed mold-like substance in ice machine. Clean and sanitize ice machine per manufacturer’s instructions to prevent mold growth.

ROACHY SAYS:

“Utensils and equipment shall be kept fully operative and in good repair. All new and replacement equipment shall be properly installed and be certified or classified for sanitation by an ANSI accredited certification program. Electrical appliances must meet UL standards. Single-use articles shall not allow migration of deleterious substances or impart colors, odors, or tastes to food. Multi-use food contact surfaces must be smooth, free of breaks, chips, and similar imperfections; free of sharp internal angles, corners, and crevices; finished to have smooth welds and joints; be accessible for cleaning and inspection. Unless specified, wood and wood wicker may not be used as a food-contact surface. Unless specified, copper and copper alloys such as brass may not be used in contact with a food that has a pH below six or for a fitting between a backflow preventer and a carbonator. Beverage tubing and cold-plate beverage cooling devices cannot be installed in contact with stored ice intended to be used as food. Equipment that is not movable must be installed to allow for cleaning in place. Cutting or piercing parts of can openers must be readily removable. Facilities that wash, rinse, soak, thaw, or similarly prepare foods shall be provided with a approved food preparation sink. Reservoirs that supply water to produce foggers must be cleaned and maintained. Surfaces such as cutting blocks and boards that are subject to scratching and scoring shall be resurfaced or replaced if they can no longer be effectively cleaned and sanitized. (114130, 114130.1, 114130.2, 114130.3, 114130.4, 114130.5, 114130.6, 114132, 114133, 114137, 114139, 114153, 114163, 114165, 114167, 114169, 114175, 114177, 114180, 114182)”

44. Premises; personal/cleaning items; vermin-proofing.

Conditions Observed: Observed “stamp refill ink” stored on top of bulk flour container. Observed tools, office supplies and equipment and other random items commingled with food and/or utensils in back food prep area and back storage area. Remove items that are unnecessary to the operation or maintenance of the facility. Separate tools, office equipment and clutter from food and utensil storage and handling areas.

ROACHY SAYS:

“All premises of a food facility shall be kept clean, fully operative, and in good repair. The premise of a food facility shall be free of litter and items unnecessary to the operation of the facility. Areas designated for employees to eat and drink shall be located so that food, clean equipent and utensils, linens, and single-use articles are protected from contamination. Personal items shall be stored in a designated area to prevent contamination of food or utensils. Food prep sinks, warewashing sinks, and handwashing sinks shall not be used for the cleaning or maintenance of tools or cleaning supplies or to dispose of mop water and similar liquid wastes. A dedicated janitorial sink with a drain shall be provided and conveniently located. A separate room, area, or cabinet shall be provided for cleaning supplies. The facility shall be kept vermin proof. Insect electrocution devices shall retain the insect within the device and shall not be located over food or utensil handling areas. (114123, 114143(a, b), 114256, 114256.1, 114256.2, 114256.4, 114257, 114257.1, 114259, 114259.2, 114259.3, 114279, 114281, 114282)”

Routine Inspection
08. Proper hot and cold holding temperatures.

Conditions Observed: Measured chopped onions 46F with probe thermometer in ice bath. Observed plastic containers sitting on top of ice. Recommend using metal containers to conduct cold temperatures to the food and fully submerging containers in ice water to the top of the food to ensure it is held at or below 41F at all times.

ROACHY SAYS:

“Except during preparation, cooking, cooling, transportation to or from a retail food facility for a period of less than thirty minutes, when time is used as the public health control, or as otherwise specified, potentially hazardous foods shall be maintained at or below 41F or at or above 135F. The following foods may be held at or below 45F: raw shell eggs, unshucked live molluscan shellfish, pasteurized milk and pasteurized milk products in original sealed containers, potentially hazardous foods held during transportation. Potentially hazardous foods held for dispensing in serving lines and salad bars may be held at 45F, not to exceed 12 hours in a 24 hour period, if unused portions are discarded. Food preparation shall not exceed two cumulative hours without a return to the required holding temperatures. (113996, 113998, 114037, 114343(a))”

28. Food separated and protected.

Conditions Observed: Observed open bulk bag of powdered sugar lacking a container. Once a bulk bag of food is opened, transfer it to a rigid container with a tight fitting lid to protect from contamination.

ROACHY SAYS:

“Food shall be protected from contamination during transportation, storage, preparation, holding, and display. Adequate and suitable counter space shall be provided for all food preparation. Food preparation shall be conducted wthin an approved food compartment or fully enclosed food facility. Open-air barbecues shall be separated from public access. (113984(a-f), 113986, 114060, 114067(a,d,e,j), 114069(a, c, d), 114077, 114089.1(c), 114143(c,e))”

31. Food storage; food storage containers identified.

Conditions Observed: Observed food on the floor in walk-in refrigerator and walk-in freezer. Store foods at least 6 inches above the floor to protect from contamination.

ROACHY SAYS:

“Adequate and suitable space shall be provided for the storage of food. Food shall be protected from contamination by storing the food in a clean, dry location, where it is not exposed to splash, dust, vermin, or other forms of contamination or adulteration, and at least six inches above the floor. Food shall not be stored in any of the following ways: in locker rooms, toilet rooms, dressing rooms, refuse rooms, mechanical rooms, under sewer lines that are not shielded to intercept potential drips, under leaking water lines, including leaking automatic fire sprinklers heads, or under lines on which water has condensated, under open stairwells or under sources of contamination. Working containers holding food or food ingredients that are removed from their original packages for use in the food facility shall be identified with the common name of the food. Non-prepackaged food may not be stored in direct contact with undrained ice. Products that are held by the permit holder for credit, redemption, or return to the distributor, such as damaged, spoiled, or recalled products shall be segregated and held in designated areas that are separated from food, equipment, utensils, linens, and single-use articles. (114047, 141049, 114051, 114053, 114055, 114067(h), 114069(b))”

34. Non-food-contact surfaces clean.

Conditions Observed: Observed non-food contact surfaces of equipment are visibly soiled (interior/exterior of refrigerators and freezers, counters, cabinets, etc.) . Clean non-food contact surfaces regularly to prevent buildup, mold growth, and/or grease accumulation.

ROACHY SAYS:

“Nonfood-contact surfaces of equipment shall be kept free of an accumulation of dust, dirt, food residue, and other debris. (114115(b))”

36. Equipment / Utensils approved; installed, clean, good repair, capacity.

Conditions Observed: Observed unapproved utensils (plastic bowls) being used to portion bulk foods in bulk food containers. Obtain approved utensils, with handles, that are smooth, durable, nonabsorbent and easy to clean. Store with handles facing up out of contact with food to protect bulk foods from cross contamination.

ROACHY SAYS:

“Utensils and equipment shall be kept fully operative and in good repair. All new and replacement equipment shall be properly installed and be certified or classified for sanitation by an ANSI accredited certification program. Electrical appliances must meet UL standards. Single-use articles shall not allow migration of deleterious substances or impart colors, odors, or tastes to food. Multi-use food contact surfaces must be smooth, free of breaks, chips, and similar imperfections; free of sharp internal angles, corners, and crevices; finished to have smooth welds and joints; be accessible for cleaning and inspection. Unless specified, wood and wood wicker may not be used as a food-contact surface. Unless specified, copper and copper alloys such as brass may not be used in contact with a food that has a pH below six or for a fitting between a backflow preventer and a carbonator. Beverage tubing and cold-plate beverage cooling devices cannot be installed in contact with stored ice intended to be used as food. Equipment that is not movable must be installed to allow for cleaning in place. Cutting or piercing parts of can openers must be readily removable. Facilities that wash, rinse, soak, thaw, or similarly prepare foods shall be provided with a approved food preparation sink. Reservoirs that supply water to produce foggers must be cleaned and maintained. Surfaces such as cutting blocks and boards that are subject to scratching and scoring shall be resurfaced or replaced if they can no longer be effectively cleaned and sanitized. (114130, 114130.1, 114130.2, 114130.3, 114130.4, 114130.5, 114130.6, 114132, 114133, 114137, 114139, 114153, 114163, 114165, 114167, 114169, 114175, 114177, 114180, 114182)”

45. Floor, walls, and ceilings: built, maintained, clean.

Conditions Observed: Observed floors are failing in food prep area. Replace floors to provide a smooth, durable, nonabsorbent surface that is easy to clean. Submit manufacturer specification sheets or floor samples to this office for approval prior to purchase and installation.

ROACHY SAYS:

“Food facilities shall be fully enclosed in a building consisting of permanent floors, walls, and an overhead structure that meets minimum standards. The walls and ceiling shall be smooth, durable, nonabsorbent, and easily cleanable. Flooring and base coving shall be smooth, durable, and made of approved nonabsorbent material that is easily cleanable. Floor surfaces shall be coved at the juncture of the floor and wall with a 3/8 inch minimum radius and shall extend up the wall at least 4 inches. (114143(d), 114266, 114268, 114268.1, 114271, 114272)”

© 2024 Lost Coast Communications Contact: news@lostcoastoutpost.com.