Sempervirens

720 Wood St, Eureka

Routine Inspection

ROACHY SAYS:

“Ooo! Welcome to Sanitarytown! Population: Sempervirens! I see lots of happy hungry mouths in this establishment's near future!!”

Routine Inspection

ROACHY SAYS:

“Take a victory lap, Sempervirens! In the race that is maintaining a clean and healthy establishment you've earned Roachy's gold medal! Eat here today, everyone!!”

Routine Inspection

ROACHY SAYS:

“Take a victory lap, Sempervirens! In the race that is maintaining a clean and healthy establishment you've earned Roachy's gold medal! Eat here today, everyone!!”

Routine Inspection

ROACHY SAYS:

“Both patrons and the health department agree! This place sets the standard for Humboldt food facility cleanliness! All hail Sempervirens!!”

Routine Inspection

ROACHY SAYS:

“Huzzah! This establishment has successfully impressed the government! Kudos, Sempervirens!!”

Reinspection

ROACHY SAYS:

“Both patrons and the health department agree! This place sets the standard for Humboldt food facility cleanliness! All hail Sempervirens!!”

Routine Inspection
36. Equipment / Utensils approved; installed, clean, good repair, capacity.

Conditions Observed: Observed condensate leak inside True 3 door freezer. Repair leak to protect foods stored in this freezer from contamination.

ROACHY SAYS:

“Utensils and equipment shall be kept fully operative and in good repair. All new and replacement equipment shall be properly installed and be certified or classified for sanitation by an ANSI accredited certification program. Electrical appliances must meet UL standards. Single-use articles shall not allow migration of deleterious substances or impart colors, odors, or tastes to food. Multi-use food contact surfaces must be smooth, free of breaks, chips, and similar imperfections; free of sharp internal angles, corners, and crevices; finished to have smooth welds and joints; be accessible for cleaning and inspection. Unless specified, wood and wood wicker may not be used as a food-contact surface. Unless specified, copper and copper alloys such as brass may not be used in contact with a food that has a pH below six or for a fitting between a backflow preventer and a carbonator. Beverage tubing and cold-plate beverage cooling devices cannot be installed in contact with stored ice intended to be used as food. Equipment that is not movable must be installed to allow for cleaning in place. Cutting or piercing parts of can openers must be readily removable. Facilities that wash, rinse, soak, thaw, or similarly prepare foods shall be provided with a approved food preparation sink. Reservoirs that supply water to produce foggers must be cleaned and maintained. Surfaces such as cutting blocks and boards that are subject to scratching and scoring shall be resurfaced or replaced if they can no longer be effectively cleaned and sanitized. (114130, 114130.1, 114130.2, 114130.3, 114130.4, 114130.5, 114130.6, 114132, 114133, 114137, 114139, 114153, 114163, 114165, 114167, 114169, 114175, 114177, 114180, 114182)”

Reinspection

ROACHY SAYS:

“Humboldt foodies rejoice! Our reports show that Sempervirens knows how to get you fed in a sanitary manner. Now that's nummy!!”

Routine Inspection
15. Food contact surfaces: clean and sanitized.

Conditions Observed: Measured chlorine sanitizer 0PPM at dishwasher. Please call Eco Lab to service the dishwasher and submit service invoice to this office for verification. In the meantime, facility will set up 3 compartment manual warewashing method and use pre-mixed QT sanitizer from the dispenser measuring 200PPM for sanitizing equipment and utensils.

ROACHY SAYS:

“Food-contact surfaces and utensils shall be clean to sight and touch. Food-contact surfaces and multiservice utensils shall be effectively washed, rinsed, and sanitized to remove or completely loosen soils by use of manual or mechanical methods. Precleaning may be required. Manual sanitization shall be accomplished during the final rinse by contact with solution containing 100 ppm available chlorine, 200 ppm quaternary ammonium, or another approved sanitizer. Mechanical sanitization shall be accomplished in the final rinse by achieving a utensil surface temperature of 160F or by contact with solution containing 50 ppm available chlorine, 200 ppm quaternary ammonium, or another approved sanitizer. After cleaning and sanitizing, equipment and utensils shall be air dried. Mechancial warewash machines must be approved and installed and operated according to manufacturer's specifications. Food contact surfaces, utensils, and equipment shall be cleaned and sanitized at the following times: before each use with different type of raw food of animal origin, when changing from raw food to ready to eat food, between uses with raw produce and potentially hazardous food, before using a thermometer, and any time during the operation when contamination may have occurred. Warewash sinks used to wash wiping cloths, wash produce, or thaw food must be cleaned and sanitized before and after these uses. Equipment, food contact surfaces, and utensils must be cleaned and sanitized throughout the day at least every four hours or as needed to prevent contamination. (114097, 114099.1, 114099.2, 114099.4, 114099.6, 114099.7, 114101, 114105, 114109, 114111, 114113, 114115(a,c), 114117, 114125(b), 114141)”

Routine Inspection

ROACHY SAYS:

“Zero violations! Now that's how you keep 'em coming back for more! I'll be sending all my human friends to Sempervirens! Yum yum!!”

© 2024 Lost Coast Communications Contact: news@lostcoastoutpost.com.