St Joseph Hospital - Café

2700 Dolbeer St, Eureka

Routine Inspection

ROACHY SAYS:

“Huzzah! This establishment has successfully impressed the government! Kudos, St Joseph Hospital - Café!!”

Routine Inspection

ROACHY SAYS:

“Huzzah! This establishment has successfully impressed the government! Kudos, St Joseph Hospital - Café!!”

Routine Inspection

ROACHY SAYS:

“Huzzah! This establishment has successfully impressed the government! Kudos, St Joseph Hospital - Café!!”

Routine Inspection
08. Proper hot and cold holding temperatures.

Conditions Observed: Measured sour cream 47F and cream cheese 47F with probe thermometer in True single door refrigerator. Adjust/repair/replace True single door refrigerator to hold cold potentially hazardous foods at or below 41F at all times.

ROACHY SAYS:

“Except during preparation, cooking, cooling, transportation to or from a retail food facility for a period of less than thirty minutes, when time is used as the public health control, or as otherwise specified, potentially hazardous foods shall be maintained at or below 41F or at or above 135F. The following foods may be held at or below 45F: raw shell eggs, unshucked live molluscan shellfish, pasteurized milk and pasteurized milk products in original sealed containers, potentially hazardous foods held during transportation. Potentially hazardous foods held for dispensing in serving lines and salad bars may be held at 45F, not to exceed 12 hours in a 24 hour period, if unused portions are discarded. Food preparation shall not exceed two cumulative hours without a return to the required holding temperatures. (113996, 113998, 114037, 114343(a))”

Routine Inspection
08. Proper hot and cold holding temperatures.

Conditions Observed: Measured beef rolled tacos 124.5F (top), 164F (bottom), 120.5F (front), 139F (rear) in hot hold unit, control #2. The beef rolled tacos shall be hot held at or above 135F at all times. The rolled tacos were pulled from the hot hold unit and discarded. Thank you for correcting this major violation on site.

ROACHY SAYS:

“Except during preparation, cooking, cooling, transportation to or from a retail food facility for a period of less than thirty minutes, when time is used as the public health control, or as otherwise specified, potentially hazardous foods shall be maintained at or below 41F or at or above 135F. The following foods may be held at or below 45F: raw shell eggs, unshucked live molluscan shellfish, pasteurized milk and pasteurized milk products in original sealed containers, potentially hazardous foods held during transportation. Potentially hazardous foods held for dispensing in serving lines and salad bars may be held at 45F, not to exceed 12 hours in a 24 hour period, if unused portions are discarded. Food preparation shall not exceed two cumulative hours without a return to the required holding temperatures. (113996, 113998, 114037, 114343(a))”

34. Non-food-contact surfaces clean.

Conditions Observed: Observed mold-like substance in ice dispenser on soda machine. Observed sticky soda residue under soda dispensers. Clean and sanitize non-food contact surfaces of the soda machine regularly to prevent mold growth and buildup.

ROACHY SAYS:

“Nonfood-contact surfaces of equipment shall be kept free of an accumulation of dust, dirt, food residue, and other debris. (114115(b))”

Routine Inspection
22. Hot and Cold Water Available

Conditions Observed: Measured hot water 118.5F at 3 compartment sink. Adjust/repair/replace water heater to deliver hot water at or above 120F at all mixing faucets at all times.

ROACHY SAYS:

“An adequate, protected, pressurized, approved potable supply of hot and cold water shall be provided at all times. Hot water shall be supplied at a minimum temperature of 120F when measured from the faucet. The temperature of water provided to handwashing facilities shall be at least 100F. Handwashing facilities equipped with non-adjustable faucets shall have their temperature set between 100F and 108F. Hot water shall be provided at the food preparation sink and janitorial sink. (113953(c), 114099.2(b), 114163(a)(3), 114189, 114192, 114192.1, 114195)”

30. Toxic substances properly identified, stored, used.

Conditions Observed: Observed one unlabeled chemical spray bottle in the facility. Label all chemicals when taken out of manufacturer’s original packaging. Employee labeled spray bottle, this minor violation was corrected on site.

ROACHY SAYS:

“Only those insecticides, rodenticides, and other pesticides that are necessary, bear a legible manufacturer's label, and are specifically approved for use in a food facility may be used in a food facility in accordance with the manufacturer's instructions. Containers used for storing poisonous or toxic materiails such as cleaners and sanitizers taken from bulk supplies shall be clearly and individually identified with the common name of the material. Poisonous or toxic materials shall be stored or displayed to prevent contamination of food, equipment, utensils, linens, and single-use articles. (114254, 114254.1, 114254.2)”

36. Equipment / Utensils approved; installed, clean, good repair, capacity.

Conditions Observed: Observed mold-like substance in ice machine (interior ceiling). Clean and sanitize ice machine per manufacturer’s instructions to prevent mold growth. Observed mold-like substance in ice dispenser on soda machine. Clean and sanitize ice dispenser on soda machine regularly to prevent mold growth.

ROACHY SAYS:

“Utensils and equipment shall be kept fully operative and in good repair. All new and replacement equipment shall be properly installed and be certified or classified for sanitation by an ANSI accredited certification program. Electrical appliances must meet UL standards. Single-use articles shall not allow migration of deleterious substances or impart colors, odors, or tastes to food. Multi-use food contact surfaces must be smooth, free of breaks, chips, and similar imperfections; free of sharp internal angles, corners, and crevices; finished to have smooth welds and joints; be accessible for cleaning and inspection. Unless specified, wood and wood wicker may not be used as a food-contact surface. Unless specified, copper and copper alloys such as brass may not be used in contact with a food that has a pH below six or for a fitting between a backflow preventer and a carbonator. Beverage tubing and cold-plate beverage cooling devices cannot be installed in contact with stored ice intended to be used as food. Equipment that is not movable must be installed to allow for cleaning in place. Cutting or piercing parts of can openers must be readily removable. Facilities that wash, rinse, soak, thaw, or similarly prepare foods shall be provided with a approved food preparation sink. Reservoirs that supply water to produce foggers must be cleaned and maintained. Surfaces such as cutting blocks and boards that are subject to scratching and scoring shall be resurfaced or replaced if they can no longer be effectively cleaned and sanitized. (114130, 114130.1, 114130.2, 114130.3, 114130.4, 114130.5, 114130.6, 114132, 114133, 114137, 114139, 114153, 114163, 114165, 114167, 114169, 114175, 114177, 114180, 114182)”

© 2021 Lost Coast Communications Contact: news@lostcoastoutpost.com.