Court House Market

905 4th St, Eureka

Routine Inspection

ROACHY SAYS:

“Ooo! Welcome to Sanitarytown! Population: Court House Market! I see lots of happy hungry mouths in this establishment's near future!!”

Routine Inspection

ROACHY SAYS:

“Huzzah! This establishment has successfully impressed the government! Kudos, Court House Market!!”

Reinspection

ROACHY SAYS:

“Ooo! Welcome to Sanitarytown! Population: Court House Market! I see lots of happy hungry mouths in this establishment's near future!!”

Routine Inspection
07. Adequate handwash facilities supplied and accessible.

Conditions Observed: Observed paper towels not stocked in paper towel dispenser at handwash sink. Keep required handwash supplies stocked in dispensers at all times for proper handwashing.

ROACHY SAYS:

“Handwashing facilities shall be provided within or adjacent to toilet rooms, food preparation, and warewashing areas. Handwashing facilities shall be clean, unobstructed, and accessible at all times. Handwashing facilities shall be provided with soap and sanitary single use towels in approved dispensers. Dispensers shall be maintained in good repair. A handwashing facility shall not be used for purposes other than handwashing. (113953, 113953.1, 113953.2, 114067(f))”

08. Proper hot and cold holding temperatures.

Conditions Observed: Measured ice cream 39F in 4 door reach in freezer. Frozen foods are required to be held at a temperature at which all moisture therein is in solid state. Measured ambient air of 4 door reach in freezer 39F. Repair/replace the freezer and submit service invoice to this office by 11/18/19 to avoid a reinspection. Operator moved frozen food items to Nestle freezer until 5 door freezer is repaired.

ROACHY SAYS:

“Except during preparation, cooking, cooling, transportation to or from a retail food facility for a period of less than thirty minutes, when time is used as the public health control, or as otherwise specified, potentially hazardous foods shall be maintained at or below 41F or at or above 135F. The following foods may be held at or below 45F: raw shell eggs, unshucked live molluscan shellfish, pasteurized milk and pasteurized milk products in original sealed containers, potentially hazardous foods held during transportation. Potentially hazardous foods held for dispensing in serving lines and salad bars may be held at 45F, not to exceed 12 hours in a 24 hour period, if unused portions are discarded. Food preparation shall not exceed two cumulative hours without a return to the required holding temperatures. (113996, 113998, 114037, 114343(a))”

22. Hot and Cold Water Available

Conditions Observed: Measured hot water 115F with probe thermometer at 3 compartment sink. Adjust/repair/replace water heater to deliver hot water at or above 120F at all mixing faucets at all times.

ROACHY SAYS:

“An adequate, protected, pressurized, approved potable supply of hot and cold water shall be provided at all times. Hot water shall be supplied at a minimum temperature of 120F when measured from the faucet. The temperature of water provided to handwashing facilities shall be at least 100F. Handwashing facilities equipped with non-adjustable faucets shall have their temperature set between 100F and 108F. Hot water shall be provided at the food preparation sink and janitorial sink. (113953(c), 114099.2(b), 114163(a)(3), 114189, 114192, 114192.1, 114195)”

31. Food storage; food storage containers identified.

Conditions Observed: Observed food stored less than 6 inches above the floor on bottom shelf of 4 door reach in freezer. Store foods at least 6 inches above the floor to prevent contamination or potential vermin attraction.

ROACHY SAYS:

“Adequate and suitable space shall be provided for the storage of food. Food shall be protected from contamination by storing the food in a clean, dry location, where it is not exposed to splash, dust, vermin, or other forms of contamination or adulteration, and at least six inches above the floor. Food shall not be stored in any of the following ways: in locker rooms, toilet rooms, dressing rooms, refuse rooms, mechanical rooms, under sewer lines that are not shielded to intercept potential drips, under leaking water lines, including leaking automatic fire sprinklers heads, or under lines on which water has condensated, under open stairwells or under sources of contamination. Working containers holding food or food ingredients that are removed from their original packages for use in the food facility shall be identified with the common name of the food. Non-prepackaged food may not be stored in direct contact with undrained ice. Products that are held by the permit holder for credit, redemption, or return to the distributor, such as damaged, spoiled, or recalled products shall be segregated and held in designated areas that are separated from food, equipment, utensils, linens, and single-use articles. (114047, 141049, 114051, 114053, 114055, 114067(h), 114069(b))”

36. Equipment / Utensils approved; installed, clean, good repair, capacity.

Conditions Observed: Observed nonfunctional fan in 4 door reach in freezer. Repair fan to ensure frozen temperatures are in compliance. Observed standing water in bottom of 4 door reach in refrigerator. Find source of water and repair.

ROACHY SAYS:

“Utensils and equipment shall be kept fully operative and in good repair. All new and replacement equipment shall be properly installed and be certified or classified for sanitation by an ANSI accredited certification program. Electrical appliances must meet UL standards. Single-use articles shall not allow migration of deleterious substances or impart colors, odors, or tastes to food. Multi-use food contact surfaces must be smooth, free of breaks, chips, and similar imperfections; free of sharp internal angles, corners, and crevices; finished to have smooth welds and joints; be accessible for cleaning and inspection. Unless specified, wood and wood wicker may not be used as a food-contact surface. Unless specified, copper and copper alloys such as brass may not be used in contact with a food that has a pH below six or for a fitting between a backflow preventer and a carbonator. Beverage tubing and cold-plate beverage cooling devices cannot be installed in contact with stored ice intended to be used as food. Equipment that is not movable must be installed to allow for cleaning in place. Cutting or piercing parts of can openers must be readily removable. Facilities that wash, rinse, soak, thaw, or similarly prepare foods shall be provided with a approved food preparation sink. Reservoirs that supply water to produce foggers must be cleaned and maintained. Surfaces such as cutting blocks and boards that are subject to scratching and scoring shall be resurfaced or replaced if they can no longer be effectively cleaned and sanitized. (114130, 114130.1, 114130.2, 114130.3, 114130.4, 114130.5, 114130.6, 114132, 114133, 114137, 114139, 114153, 114163, 114165, 114167, 114169, 114175, 114177, 114180, 114182)”

44. Premises; personal/cleaning items; vermin-proofing.

Conditions Observed: Observed front door propped open during the inspection. The facility is to remain vermin proof at all times. Keep door closed, or install a screen or air curtain to prevent entrance or harborage of animals, birds and vermin, including but not limited to insects and rodents.

ROACHY SAYS:

“All premises of a food facility shall be kept clean, fully operative, and in good repair. The premise of a food facility shall be free of litter and items unnecessary to the operation of the facility. Areas designated for employees to eat and drink shall be located so that food, clean equipent and utensils, linens, and single-use articles are protected from contamination. Personal items shall be stored in a designated area to prevent contamination of food or utensils. Food prep sinks, warewashing sinks, and handwashing sinks shall not be used for the cleaning or maintenance of tools or cleaning supplies or to dispose of mop water and similar liquid wastes. A dedicated janitorial sink with a drain shall be provided and conveniently located. A separate room, area, or cabinet shall be provided for cleaning supplies. The facility shall be kept vermin proof. Insect electrocution devices shall retain the insect within the device and shall not be located over food or utensil handling areas. (114123, 114143(a, b), 114256, 114256.1, 114256.2, 114256.4, 114257, 114257.1, 114259, 114259.2, 114259.3, 114279, 114281, 114282)”

45. Floor, walls, and ceilings: built, maintained, clean.

Conditions Observed: Observed missing or damaged ceiling panels throughout the facility. Repair/replace ceiling panels. Observed floor tiles failed throughout facility. Replace floor with a minimum 3/8 inch radius coving that extends 4 inches up the wall, to provide a surface that is smooth, durable, nonabsorbent and easy to clean. Submit floor samples or specification sheets to this office for approval prior to purchase and installation.

ROACHY SAYS:

“Food facilities shall be fully enclosed in a building consisting of permanent floors, walls, and an overhead structure that meets minimum standards. The walls and ceiling shall be smooth, durable, nonabsorbent, and easily cleanable. Flooring and base coving shall be smooth, durable, and made of approved nonabsorbent material that is easily cleanable. Floor surfaces shall be coved at the juncture of the floor and wall with a 3/8 inch minimum radius and shall extend up the wall at least 4 inches. (114143(d), 114266, 114268, 114268.1, 114271, 114272)”

Routine Inspection
34. Non-food-contact surfaces clean.

Conditions Observed: Observed floor sink in back room is clogged and full of debris. This drain must be repaired immediately to prevent wastewater from backing up into the facility, in which a permit suspension would be required. Contact this office when drain is repaired for verification.

ROACHY SAYS:

“Nonfood-contact surfaces of equipment shall be kept free of an accumulation of dust, dirt, food residue, and other debris. (114115(b))”

44. Premises; personal/cleaning items; vermin-proofing.

Conditions Observed: Observed front door to facility propped open during the inspection. The facility shall remain vermin proof, and thus the front door shall remain closed at all times to prevent entrance of vermin including animals, birds and insects. You may keep the door open if a screen or air curtain is installed.

ROACHY SAYS:

“All premises of a food facility shall be kept clean, fully operative, and in good repair. The premise of a food facility shall be free of litter and items unnecessary to the operation of the facility. Areas designated for employees to eat and drink shall be located so that food, clean equipent and utensils, linens, and single-use articles are protected from contamination. Personal items shall be stored in a designated area to prevent contamination of food or utensils. Food prep sinks, warewashing sinks, and handwashing sinks shall not be used for the cleaning or maintenance of tools or cleaning supplies or to dispose of mop water and similar liquid wastes. A dedicated janitorial sink with a drain shall be provided and conveniently located. A separate room, area, or cabinet shall be provided for cleaning supplies. The facility shall be kept vermin proof. Insect electrocution devices shall retain the insect within the device and shall not be located over food or utensil handling areas. (114123, 114143(a, b), 114256, 114256.1, 114256.2, 114256.4, 114257, 114257.1, 114259, 114259.2, 114259.3, 114279, 114281, 114282)”

45. Floor, walls, and ceilings: built, maintained, clean.

Conditions Observed: Observed missing or damaged ceiling panels throughout the facility. Repair/replace ceiling panels. Observed floor tiles failing under 3 compartment sink, in front of walk-in refrigerator and inside walk-in refrigerator. Replace floor to provide a surface that is smooth, durable, nonabsorbent and easy to clean. Submit floor samples or specification sheets to this office for approval prior to purchase and installation.

ROACHY SAYS:

“Food facilities shall be fully enclosed in a building consisting of permanent floors, walls, and an overhead structure that meets minimum standards. The walls and ceiling shall be smooth, durable, nonabsorbent, and easily cleanable. Flooring and base coving shall be smooth, durable, and made of approved nonabsorbent material that is easily cleanable. Floor surfaces shall be coved at the juncture of the floor and wall with a 3/8 inch minimum radius and shall extend up the wall at least 4 inches. (114143(d), 114266, 114268, 114268.1, 114271, 114272)”

© 2021 Lost Coast Communications Contact: news@lostcoastoutpost.com.